Publicité
Les langues disponibles
Les langues disponibles
Remove handlebar controls, clutch lever bracket and brake cylinder assy, then remove the
original handlebar.
Assure that the front wheel is free from any load when dismounting top yoke, also
have a look on page 3 because now it's easy to re-route. Then swap top yoke. To demount
the ignition lock you mostly have to drill out the heads of the breakaway screws. Fit the ignition
lock with the attached bushings, new bolts and corrugated washers underneath the bolts' heads,
at the LSL-yoke. You should drill out the hexagon sockets of the screws as theft protection. To fix
top yoke, first tighten steering head nut up to 15Nm / 11lbf ft, then fix the slider-tube clamping
bolts with 20Nm / 14.75lbf ft. Now tighten steering head up to the original torque, which refers to
the manufacturer's instruction. Fit hazard switch with retaining bracket (25mm) and M6x12 as it is
mounted on the original yoke.
Recommended handlebar type: LSL-Superbike, flat / Type N1 or XN1
Mount new handle bar into the clamps. Tighten the handlebar clamps evenly and tighten them
with 25Nm / 18.44lbf ft torque when fitment is done.
Fairing: Unscrew the mirrors and rebore the fairing support (Ø6.5mm) with a new diameter of
8.5mm. Place rubber spacers (Ø8.5xØ25x6) between fairing support and fairing. The screen
needs to be cut out by approximately 60mm or to be replaced by a suitable one.
Modify the steering stop!
To gain more clearance between
handlebar and fairing you have
to modify the steering stop. Use
suitable glue to fix the aluminium
shims (t=2mm) on the steering
stop.
To
clearance for the handlebar
controls,
bar
recommended (part-no.: 135-
004.. or 135-001A..) so you can
mount the controls more to
the
outside,
projecting over the bar ends.
Disconnect the signal-horn first; afterwards check
the clearance to the tank and faring. Therefore
you have to mount all controls provisorily on the
handlebar. Now mark and drill the bores for the
anti-twist protections and fix the controls finally. The
left grip should be installed with glue. Mount brake
fluid reservoir as shown.
————————————————
Rev. 00 10/02/2014
assure
enough
ends
are
with
grips
Accessories from
The Original
—
Page 2 of 4
——
Publicité
