Fagor LAP-08 Manuel D'utilisation page 43

9 CONFIGURATION
9.1 Programme management
If the washing machine is configured in self-service mode, only the first 16 programmes will be available, the
remaining programmes become available on entering Credit Mode".
9.2 Configure System
9.2.1 Advanced configuration
Access: [Main screen]
The following sections can be configured in the system configuration, as in "Credit mode" (See section 4.2):
•
Next screen.
•
Previous screen.
•
Language: The washing machine texts can be displayed in 34 different languages, although the
texts can only be edited using Western character sets.
•
Time: Configuration of the current time. The display format (12 hour / 24 hour (default setting)) can
be selected.
•
Date: Configuration of the current date. The display format (dd/mm/yyyy (default setting) /
yyyy/mm/dd / mm/dd/yyyy) can be selected.
•
Units of measurement: The unit of measurement in which the temperature (ºC (default setting) or
ºF), the weight (Kg (default setting) or lb) and the size (mm (default setting) or in) can be selected.
•
Thermal stop: General configuration of the thermal stop. If this is disabled, the thermal stop does
not take place even if this parameter is active in the currently running cycle. If, however, it is enabled,
the configuration of each cycle is respected and the consequent action is taken. By default it is active.
•
Water saving by weight: The required water saving for the weight can be configured. Three
different weight options and three levels of saving can be selected.
Depending on the load, there will be a reduction in the water level and detergent dose.
•
Levels: This enables the configuration in mm of the 5 configurable levels. Each level type will have
a default value and configuration range. These values will depend on the model selected. (See table of
levels by model).
•
Speed: This enables the configuration in RPM of the different types of speed existing, in both the
wash and spin cycles. Each speed type has a minimum and maximum configuration value. (See table of
RPM/V equivalences by model).
Translation of original instructions.
[Main Menu]
39