Foppapedretti Run Notice D'utilisation page 40

In group 76-105cm, the adjustment of the headrest also changes the height of the
shoulder straps.
USING THE BUCKLE
To attach the buckle: Hold together the central buckle tabs and insert them in the
special slot inside the harness buckle. A "click" will indicate that it has attached
correctly (fig. 4).
To release the buckle: Press the red button to remove the tabs from the central buckle
(fig. 5).
ADJUSTING THE SEAT BELT (HARNESS)
To loosen the harnes: Press the adjustment button and at the same time grip the
straps (chest belts) at the bottom, under the pads of the chest protectors, and pull them
forwards to loosen them (fig. 6).
IMPORTANT: Do not pull on the shoulder pads.
Tightening the harness: Pull the harness adjustment strap so as to tighten it properly
against the body of the child (fig. 7a, 7b). The harness is correctly tightened when the
gap between the harness and the child is no greater than the thickness of your finger
(1 cm) (fig. 4B).
☞ NOTE: check that the buckle is secured by tugging the shoulder and waist straps.
☞ ATTENTION: Do not twist or overlap the harness straps.
RECLINING THE SEAT
From 76 to 105 cm: the seat of the car seat can be reclined in 5 different positions
•
(pos. 1, 2, 3, 4, 5) fig. 8c;
From 100 to 150 cm: the seat of the car seat can be reclined only in 1 position
•
(fig.8c).
To adjust the tilt: Press the adjustment handle located under the front of the car seat
and, holding it down, pull or push the seat forwards or backwards. Release the handle
when the seat is in the desired position and make sure that it is locked correctly; you will
hear a "click" when the seat has attached (fig. 8a, 8b, 8c).
HOW TO INSTALL THE ISOFIX SYSTEM
If your car does not have standard ISOFIX connector guides, insert those supplied with
the car seat with the recess facing upwards in the two ISOFIX anchoring points in the
car (fig. 9).
☞ SUGGESTION: The ISOFIX anchoring points are located between the seat and the
backrest of the passenger seat.
Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click". The indicator on both brackets will turn green,
confirming that they have attached (fig. 10, fig.11, fig. 12, fig. 13, fig.14, fig 15).
Check that both brackets are correctly fastened (fig. 16).
• ENGLISH •
USE IN THE VEHICLE
40