Publicité
Les langues disponibles
Les langues disponibles
Restoring factory settings
12 Restoring factory settings
The factory settings of the device
can be restored. If you do this, you
will lose all your settings.
To restore the factory settings of the
floor heating controller, proceed as
follows:
• Press and hold the system button
(A) for 4 seconds until the LED (A)
starts to quickly flash orange
(see
figure).
• Release the system button.
• Press and hold the system button
again for 4 seconds, until the LED
lights up green.
• Release the system button to con-
clude the procedure.
The device will perform a restart.
13 Maintenance and cleaning
The device does not require you
to carry out any maintenance
other than replacing the battery
when necessary. Leave any main-
tenance or repair to a specialist.
Clean the device using a soft, clean,
dry and lint-free cloth. You may damp-
en the cloth a little with lukewarm
water to remove more stubborn marks.
Do not use any detergents containing
solvents, as they could corrode the
plastic housing and label.
14 General information about
radio operation
Radio transmission is performed on
a non-exclusive transmission path,
which means that there is a possibility
of interference occurring. Interference
can also be caused by switching oper-
ations, electrical motors or defective
electrical devices.
The transmission range within
buildings can differ significantly
from that available in open space.
Besides the transmitting power
and the reception characteristics
of the receiver, environmental
factors such as humidity in the
vicinity play an important role, as
do on-site structural/screening
conditions.
eQ-3 AG, Maiburger Strasse 29,
26789 Leer, Germany, hereby de-
clares that the radio equipment type
Homematic IP HmIP-FALMOT-C12 is
compliant with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address:
com
www.homematic-ip.
40
Publicité
