Publicité
Les langues disponibles
Les langues disponibles
Start-up
Permitted cable cross-sections for
connecting to the connecting termi-
nals (H) of the floor heating controller:
Rigid cable: 0.12 – 0.50 mm
7.2
Installation
Connect the floor heating con-
troller to a 230 V socket using the
enclosed mains cable to supply it
with power or use the connecting
terminal (H) to connect 24 V DC
(SELV).
To install the floor heating controller,
proceed as follows:
• Pull the cover (E) downwards to
open it.
Figure 5
• (Optionally) connect a 24 V DC
connecting cable to the connect-
ing terminal (H). To connect and
loosen the individual wires, press
the orange clamp using a small
screwdriver.
• Connect your heating circuit valve
drives' connecting cables to the
connecting sockets (I).
• (Optionally) connect your exten-
sion box's connecting cable to the
connecting socket (J).
• Close the cover again by position-
2
7.3
If the device has not yet been paired,
pairing mode will be enabled on the
floor heating controller during the first
3 minutes after the mains voltage has
been switched on. You will find further
information about connecting your
device in the next section.
All connected valve drives are fully
opened one after the other. The valve
drives will then complete an adjust-
ment run to determine the valve clos-
ing position.
7.4
ing it in the dedicated guide rail
and push the cover upwards.
• Connect the (optional) mains cable
to a socket.
Behaviour after switching on the
mains voltage
The display (B) is continuously on
once the mains voltage is
switched on.
Each heating zone will be shown
on the display according to the
valve position after a successful
adjustment run.
Pairing
Please read this entire section
before starting the pairing proce-
dure.
For more information on pairing
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
30
Publicité
