Télécharger Imprimer la page

HomeMatic IP HmIP-FALMOT-C12 Notice D'installation Et D'emploi page 25

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
Package contents
1
Package contents
Floor heating controller – 12
1x
channels, motorised
2x Screws, 4.0 x 40 mm
2x Wall plugs, 6 mm
1x Power cable
1x Operating manual
2 Information about this
manual
Please read this manual carefully be-
fore operating your Homematic IP
components. Keep the manual so you
can refer to it at a later date if you need
to. If you hand over the device to other
persons for use, please hand over this
manual as well.
Symbols used:
Important! This indicates a haz-
ard.
Please note. This section contains
important additional information!
3 Hazard information
Do not open the device. It does
not contain any parts that need to
be maintained by the user. In the
event of an error, please have the
device checked by an expert.
For safety and licensing reasons
(CE), unauthorised change and/or
modification of the device is not
permitted.
The device may only be operated
in a dry and dust-free environ-
ment and must be protected from
the effects of moisture, vibrations,
solar or other methods of heat
radiation, cold and mechanical
loads.
Do not use the device if there are
signs of damage to the housing,
control elements or connecting
sockets, for example. If you have
any doubts, have the device
checked by an expert.
The device is not a toy: do not
allow children to play with it. Do
not leave packaging material lying
around. Plastic films/bags, pieces
of polystyrene, etc., can be dan-
gerous in the hands of a child.
We accept no liability for damage
to property or personal injury
caused by improper use or the
failure to observe the hazard
warnings. In such cases, all war-
ranty claims are void. We accept
no liability for any consequential
damage.
The device may only be used for
fixed installations. The device
must be securely attached within
a fixed installation.
The actuator is part of the building
installation. Observe the relevant
national standards and directives
during planning and set-up. Only
qualified electricians (to VDE
0100) are permitted to carry out
work on the 230 V mains. The
applicable accident prevention
regulations must be observed
while such work is being carried
25

Publicité

loading