HomeMatic IP HmIP-FALMOT-C12 Notice D'installation Et D'emploi page 31

Start-up
You must initially add the floor heat-
ing controller to integrate it into your
system and enable it to communicate
with other devices.
You can either pair the floor heat-
ing controller directly with other
Homematic IP devices (e.g. the wall
thermostat or the Multi IO Box) or add
it to the Homematic IP Access Point.
After pairing, the device is configured
at the wall thermostat. After pairing
with the Access Point, the device is
configured in the Homematic IP app.
7.4.1 Pairing with a Homematic IP
Wall Thermostat
Please make sure you maintain a
distance of at least 50 cm be-
tween the devices during pairing.
You can cancel the pairing proce-
dure by briefly pressing the sys-
tem button (A) again. This will be
indicated by the device LED (A)
lighting up red.
Figure 6
If no pairing operations are per-
formed, pairing mode is exited
automatically after 3 minutes.
If you would like to pair the floor heat-
ing controller with a Homematic IP
Wall Thermostat, the pairing mode of
both devices has to be enabled first. To
do this, proceed as follows:
• Briefly press the channel button (C)
to select which channel you would
like to pair a device with. Press
once for channel 1, twice for chan-
nel 2, etc. The respective channel is
shown on the display (B).
Figure 7
• Press and hold the system but-
ton (A) for 4 seconds until the LED
starts to quickly flash orange. The
pairing mode of the selected chan-
nel remains enabled for 3 minutes.
• Press and hold the system button
of the wall thermostat for at least
4 seconds to enable the pairing
mode. The device LED flashes or-
ange.
The device LED (A) lights up green to
indicate that pairing has been success-
ful.
If pairing failed, the device LED lights
up red. Please try again.
31