HomeMatic IP HmIP-FALMOT-C12 Notice D'installation Et D'emploi page 36

Manual operation
For further information regarding
the configuration, please refer to
the User Manual of the wall ther-
mostat (HmIP-WTH-2).
9 Manual operation
You can manually restart adjustment
runs at individual heating zones, or
open or close individual heating zones
for installation and test purposes.
To manually start an adjustment run,
proceed as follows:
• Use the channel button (C) to se-
lect the desired channel
figure).
• Press the select button (D) until the
display (B) shows the open-ended
wrench next to the selected chan-
nel.
Figure 8
To manually switch on or switch off a
heating zone, proceed as follows:
(see
The heating zone now opens or closes
the heating zone's valve for 15 minutes.
Afterwards, normal operation will be
continued for the heating zone.
If you would like to restart the
adjustment run in all heating zo-
nes, you can also select all chan-
nels with the channel button
(press until all channels appear on
the display) and press the select
button until the open-ended
wrench appears on the display
next to heating zone "1".
• Use the channel button (C) to se-
lect the desired channel
(see figure).
• Briefly press the select button (D)
(see figure).
If you would like to simultaneous-
ly open or close the valves of all
heating zones, select all channels
and briefly press the select button
(D) (see figure).
36