HomeMatic IP HmIP-FALMOT-C12 Notice D'installation Et D'emploi page 33

Configuration using the Homematic IP Wall Thermostat
• Select "Add device".
• Briefly press the system button
(A) until the LED (A) slowly starts
flashing orange. Pairing mode for
the selected channel is active for 3
minutes (see
You can manually start the pairing
mode for another 3 minutes by
briefly pressing the system button
(A)
(see figure).
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four dig-
its of the device number (SGTIN) in
your app, or scan the QR code. The
device number is on the sticker in
the package contents or attached
to the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
lights up green. The device is now
ready for use.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• In the app, give the device a name
and allocate it to a room.
figure).
8 Configuration using
the Homematic IP Wall
Thermostat
The Homematic IP Floor Heating
Controller can be configured
using the Homematic IP Wall
Thermostat (HmIP-WTH-2), using
the Homematic IP Access Point
together with the smartphone
app, or using the WebUI of the
Homematic Central Control Unit
CCU3.
To configure the floor heating control-
ler using the wall thermostat, proceed
as follows:
• Press and hold the control wheel
of the wall thermostat to open the
Configuration menu.
• Select the
the control wheel and confirm by
pressing the control wheel briefly.
• Use the control wheel to select the
desired floor heating controller
("FALx").
• Please define if you would like to
configure the device parameters
("UnP1/UnP2") or the channel pa-
rameters ("ChAn").
All the settings that are made
under "UnP1/UnP2" will be applied
to the entire device. All settings
that are made under "ChAn" will
be applied to the single channels
of the device.
• To individually configure decalcify-
ing runs, humidity limits and heat-
ing and cooling mode details, etc.,
please proceed as follows.
symbol by turning
33