Publicité
Les langues disponibles
Les langues disponibles
3 Follow the below procedures in order to drain water.
The product has an emergency water draining hose, in order to drain the water:
4
Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
116 / EN
a
Pull the emergency draining hose out from its seat
b
Place a large container at the end of the hose. Drain
the water into the container by pulling out the plug at
the end of the hose. When the container is full, block
the inlet of the hose by replacing the plug. After the
container is emptied, repeat the above procedure to
drain the water in the machine completely.
c
When draining of water is finished, close the end by
the plug again and fix the hose in its place.
d
Turn and remove the pump filter.
Washing Machine / User Manual
Publicité
