SilverCrest SHSS 18 B1 Mode D'emploi page 13

3) Start by pulling the EPA filter
6
the coarse filter
(Fig. 4). Tap out both parts over a rubbish bin
or similar. If necessary, you can rinse out the
5
EPA filter with fresh water. Allow it to air
dry fully afterwards.
Fig. 4
4) Empty the dirt container
bin or similar.
5) First re-insert the coarse filter
5
dry EPA filter .
6) Replace the dirt container
3
element by first pushing the lower catch on
the hand element
7
container . Then, press the upper part of the
7
dirt container onto the hand element
until the dirt container
and sits firmly.
Cleaning the appliance
Wipe the appliance with a damp cloth. For stub-
born dirt, add a little mild detergent to the cloth. En-
sure that the appliance is completely dry before
using it again.
Cleaning the rotary brush
r
The rotary brush should be checked regularly
for blockages; any hair, threads or dirt should be
removed. Remove the rotary brush
1) Turn the floor nozzle upside down.
2) Push the catch on the cover plate towards
the symbol and remove the cover plate
(Fig. 5).
3) Remove the rotary brush
│ GB │ IE
■ 10
5
and then
out of the dirt container
7
into the rubbish
6
and then the
7
onto the hand
3
into the recess on the dirt
7
clicks into place
r
as follows:
r
.
4) Remove any dirt (on both sides of the brush
7
bristles) and clean the rotary brush
To do this, take a damp cloth and wipe the
individual bristle bundles from the inside to
the outside.
5) To replace the rotary brush
broad end onto the drive shaft so that the
rotary brush
6) Then, push the other end into the mount so
that the rotary brush
nozzle.
7) Reattach the cover plate until it clicks firmly into
place. The cover plate locks automatically as
the latch moves towards the
3
Fig. 5
Storage
■ When you are not using the appliance, place
it on the cradle
■ Store the 2-in-1 crevice and brush attachment
z
in the accessory compartment
■ Alternatively, you can put the brush nozzle and
crevice nozzle into the accessories holder
individually or together.
■ Store the appliance in a dust-free and dry
location.
r
, first push the
r
hooks into place.
r
sits straight in the floor
symbol (Fig. 5).
o
.
a
SHSS 18 B1
r
.
.
s