MIRKA LEROS 950 Instructions D'utilisation page 63

Replacing the brake seal
Remove the backing pad as described above.
1.
2. Pull the old brake seal out of its groove.
3. Fit the new brake seal in the groove.
Fit the backing pad as described above.
4.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service, your Mirka dealer or go to www.mirka.com
Troubleshooting guide
Symptom
The multi-purpose LED flashes
between red and green.
No light from multi-purpose LED
when switched on.
The multi-purpose LED is red and
the sander slows down to 4,000 rpm
when sanding.
The multi-purpose LED is red and
rpm is slightly reduced.
The sander has stopped and multi-
purpose LED is red.
Disposal information
DANGER
Render redundant power tools unusable by removing the power cord.
Observe applicable country-specific regulations regarding disposal and recycling of disused machines,
packaging and accessories.
EU only: Do not dispose electric power tools in house-hold waste. According to European Directives
on waste electrical and electronic equipment and its implementation under national law, electric
tools that have reached the end of their life must be collected separately and taken to an environ-
mentally compatible recycling facility.
For more information regarding REACH, RoHS and our corporate social responsibility visit
www.mirka.com
Possible cause
Connected to a mains outlet with
wrong voltage.
Power cord not properly attached to
the sander or to the mains socket.
Connected to a mains outlet with a
blown fuse.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
The tool is in safety mode due to high
temperature.
Solution
Connect the sander to a mains outlet
that correspond with the nominal
voltage of the tool.
Connect it properly.
Check the main fuse in the power
supply.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
Wait until the tool has cooled down.
Mirka® LEROS(-S) 950
en (original)
63