MIRKA LEROS 950 Instructions D'utilisation page 62

en (original)
Switching on, changing speed and stopping the sander are described in the "Multi-purpose LED indications (see Figure
2)" chapter.
The max rpm can be adjusted by pressing speed+ or speed , Figure 2. The rpm can be adjusted in the range 4,000 to
8,000 rpm.
When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
It is strongly recommended that the tool is used in combination with a Mirka Dust Extractor.
Multi-purpose LED indications (see Figure 2)
Indication
Multi-purpose LED shows green
Multi-purpose LED shows green
Multi-purpose LED flashes green/red
Multi-purpose LED shows red
Multi-purpose LED quick-flashes green / red
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to MyMirka app through which
additional tool functionality can be accessed. For more information on the app functionality and if it is available in your
country, go to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
Connect the power cord to mains outlet.
1.
2. Press and hold the Speed+ button while switching the tool on with the On/Off button.
3. Communication status LED starts blinking blue, to indicate that Bluetooth is active. The LED turns solid when
connection is established.
4. Bluetooth is deactivated when the tool is disconnected from mains outlet.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
®
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad and interface
Tools required: Hex socket 19 mm, Torx T8 screwdriver and flat head screwdriver.
1. Remove hole screws (8 pcs).
Remove the interface.
2.
Remove the cover cap. Untighten the screw to remove the backing pad.
3.
4. Remove the screw.
5. Remove the old pad.
Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket.
6.
Attach the cover cap.
7.
8. Fit a new interface.
9. Refit hole screws (8 pcs).
62
Mirka® LEROS(-S) 950
® LEROS(-S) as follows:
Meaning
Power connected
Tool switched on. Speed indication active.
Speed indication shows chosen speed.
Over temperature
Voltage out of range