SilverCrest SKM 600 D3 Mode D'emploi page 32

Overheating protection
The device has an overheating protection
system. If the motor becomes too hot, the de-
vice automatically switches itself off:
1. Switch off the device.
2. Pull out the mains plug 3.
3. Allow the device to cool down to room
temperature.
When the device has cooled down suffi-
ciently, it can be switched on again.
8.3 Switching the device on/
off and selecting speed
WARNING! Risk of material damage!
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
NOTE: the device may move slightly while
you are processing large quantities of dough.
1. Switch the device on by turning the
speed control 2 clockwise.
2. Start at a slightly lower speed, and slowly
increase to the desired speed (see "Over-
view of functions" on page 27).
3. Reduce the speed to speed 1 - 2 when
you are adding ingredients during oper-
ation through the filling opening 11.
4. Set the speed control 2 to 0 to switch
the device off.
NOTE: above all, the ideal speed depends
on the consistency of the material being
blended. The more liquid the contents, the
faster you can blend them.
8.4 Pulse function
• By turning the speed control 2 to the po-
sition , you can briefly increase the
speed to the highest setting (8).
30 GB
9. Dismantling the
device
DANGER from rotating parts!
Turn off the device and unplug the
mains plug 3 from the wall socket be-
fore disassembling the device.
Lifting up the drive arm
1. Press the unlock button 1 and fold up
the drive arm 13 until it engages and
the unlock button 1 pops out again.
Removing the mixing tool
2. Figure C: Push the mixing tool 4/6/7
slightly upwards and turn it anticlock-
wise until it can be pulled off the ax-
le 10.
Removing the splash guard
3. Turn the splash guard 12 towards the
open lock symbol until it can be re-
moved.
Removing the mixing bowl
4. Turn the mixing bowl 5 towards the
open lock symbol until it can be re-
moved.
Lowering the drive arm
5. Press the unlock button 1 and move the
drive arm 13 all the way down. The un-
lock button 1 pops out again.