SilverCrest SKMS 900 A1 Mode D'emploi page 30

7.2 Filling volumes
Always fill the water tank 14 at least up to
the marking for 4 cups (4). The maximum fill-
ing level reaches up to the marking max 10
(for approx. 10 cups).
7.3 Brewing coffee
1. Press the lever to open the lid of the
pot 7. Now fill fresh, cold tap water into
the pot 8. (Hot or carbonated water can
result in malfunctions.)
2. Lift up the cover 15 of the coffee ma-
chine.
3. Now fill the water into the water tank 14
up to the desired number of cups (max 10,
for approx. 10 cups). Make sure that the
lid of the pot 12 does not open when
pouring.
4. Hold the filter holder 4 by its handle 3
and lower it into the coffee machine.
5. Fold down the handle 3 of the filter hold-
er 4.
6. Place the permanent filter 2 into the filter
holder 4.
7. Place coffee powder into the permanent
filter 2. For medium-strength coffee, put
one coffee spoon 10 (around 7 – 8 g) of
coffee powder per cup into the filter.
Use ground coffee powder for filter cof-
fee. If you grind the coffee yourself,
grind it to a medium degree of grind-
ing.
NOTE: you can also use a paper filter. In
this case, the permanent filter 2 must not be
inserted, however. Place a paper filter
(size 1x4) with folded sides directly into the
filter holder 4. When it is folded, the paper
filter fits better in the filter holder 4 and the
seams are prevented from tearing.
8. Close the cover 15.
9. It is important that the pot 8 has
a closed lid 12 when it is placed
on the hot plate 9.
28 GB
10.Connect the mains plug on the device to
a designated wall socket. A short beep
signal sounds. On the touch display 6
of the device appears "12:00" and the
initially flashing WiFi symbol on top
. The device is in standby mode.
11.Now briefly press the standby button
once. The red indicator light is lit and
CLOCK appears on the touch dis-
play 6. The brewing process will start
after a short time.
12.The hot plate 9 remains active for ap-
prox. 30 minutes. It then switches itself
off automatically and the red light goes
out.
NOTE: by pressing the standby button
on the touch display 6, you can cancel the
brewing process and switch off the hot
plate 9 sooner at any time. Instead of the
red indicator light, the white one is lit.