Adjusting the tilt of the projector
with the front feet (adjustable)
When the projector is installed on an uneven
surface, you can adjust using the front feet
(adjustable).
Notes
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the projector
with the front feet (adjustable) extended. It
may cause a malfunction.
Displaying a pattern for adjusting
an image
You can display a pattern for adjusting the
projected image with the PATTERN key on
the Remote Commander. Use V/v to change
the pattern and B/b to change its color.
Press the PATTERN key again to restore the
previous image.
Turning Off the Power
1
Press the ?/1 key on the main unit or
the 1 key on the Remote Commander.
The projector starts shutdown and turns
off.
Note
Do not turn off the projector soon after the
lamp lights. It may cause a malfunction of
the lamp (does not light ,etc.).
2
Unplug the AC power cord from the
wall outlet.
To turn off without displaying
confirmation message
?/1
Press and hold the
few seconds.
16
GB
Projecting
key on the unit for a
Notes
• If you turn off the unit soon after the lamp is
turned on, the confirmation message will be
displayed and may take a longer time for the
unit to turn off.
• If you turn on the unit soon after the unit is
turned off, it may take a longer time for the
unit to put out the image.
If you need to further adjust projected
images, refer to "Projecting/Adjusting an
Image" in the Operating Instructions
contained in the supplied CD-ROM.