Publicité
Les langues disponibles
Les langues disponibles
5.6 Oscillation function
Press the oscillation button
oscillation of the unit on or off.
When successfully activated, the selected
oscillation level is shown on the display 4 .
You can choose between 4 levels of 30°-60°-
90°-120°.
The oscillation function causes the discharged
air to be distributed from left to right.
To deactivate the oscillation function, press the
oscillation button
the display.
6. Control with the remote control
6.1 Switch on the unit
Note: The keys have a signal tone feedback (for
signal tones see point 6.7).
Press the key
13
The unit starts directly in ventilation level "003"
when it is first put into operation.
During further use, the unit starts at the same
ventilation level that was selected during the last
operation.
6.2 Switch off the unit
To return the unit to standby mode after
operation, press the button
NOTE: The unit switches off while the display 4
shows "000" for approx. 10 seconds and then also
switches off.
6.3 Select operating mode
To change an operating mode, press the but-
ton
7 repeatedly until the desired mode
is shown on the display 4 . You can choose
between power, sleep and nature modes.
14
GB/IE/NI/CY/MT
3 to switch the
3 until "000" appears on
to switch on the product.
.
13
6.4 Selecting ventilation levels
Press the button
the ventilation level you want.
Press the button
the ventilation level you want.
You can choose between 20 different ventilation
levels.
The desired ventilation level is adopted directly.
Display
Operating mode
Power mode
-P-
The unit switches to the highest level
of ventilation mode
Sleep mode
The maximum speed in sleep mode
is level 10. In sleep mode, the speed
is reduced by 4 levels and increases
by 2 levels after 10 seconds and
-S-
again by 2 levels after a further
10 seconds. The set speed is then
reached again. This interval runs for
30 minutes. After this time, the unit
reduces the speed by 2 levels each
time. This is repeated until level 2 is
reached.
Nature mode
Simulation of natural gusts of wind.
Every 10 seconds, the speed is
-n-
reduced or increased by 4 levels of
the set ventilation level.
Note: The lowest speed that can be
set in natural mode is therefore level
5 and the highest speed is level 16.
6.5 Timer function
The timer is used to switch off the unit automatically
after a preset time. The timer function can be set in
hourly intervals of up to 8h.
repeatedly to increase
10
repeatedly to decrease
11
Publicité
