Télécharger Imprimer la page

SilverCrest SRV35A1 Instructions D'utilisation Et Consignes De Sécurité page 12

Ventilateur sur pied

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
3. Before commissioning
3.1 Device Installation
Remove all packaging material and all trans-
port bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the fol-
lowing requirements:
The floor should be firm, flat and horizontal.
Minimum distances of 30 cm to the side, 30 cm
to the top, 30 cm to the rear and 1 m to the front
must be maintained from the enclosure.
Do not place the unit in a hot, wet or very humid
environment.
The socket must be easily accessible so that the
mains connection cable can be easily discon-
nected if necessary.
Temperature range: from 0 to +40 °C
Air humidity (no condensation): 5–75 %
3.2 Remote control: How to insert or change
the battery
The remote control unit is delivered together with
a lithium button cell
control, remove the plastic tape that protrudes
from the battery compartment
1
If the remote control battery needs to be re-
placed, insert a new 3-volt lithium button cell.
Pay attention to the type of lithium button cell
(CR2025).
12
GB/IE/NI/CY/MT
  . To enable the remote
16
(see Figure 1).
14
Press the tab
on the battery compartment
15
of the remote control toward the centre. Now pull
out the battery compartment
2
16
15
Remove the old battery
Insert a new 3V-button-cell battery (type
CR2025). Pay attention to the correct polarity.
Push the battery compartment
mote control unit until the tab
4. Starting Up
4.1 Standby mode
Connect the jack plug of the mains adapter
to the unit and then plug the mains adapter
into a socket. The unit is now supplied with pow-
er. A short beep sounds.
"888" appears on the display 4 before a circle
movement is displayed for approx. 10 seconds
(charging process) when the unit starts up.
5. Control on the unit
5.1 Switch on the unit
Note: The keys have a signal tone feedback (for
signal tones see point 6.7).
Press the key
1 to switch on the product.
The unit starts directly in ventilation level "003"
when it is first put into operation.
14
(see Figure 2).
14
14
 .
16
back into the re-
14
snaps into place.
15
17
17

Publicité

loading

Ce manuel est également adapté pour:

102023Lb08-01