Télécharger Imprimer la page

Fulgor Milano FCH 604 ID TS BK Mode D'emploi Pour L'installation page 31

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Switching on the cooking zones
The power of each individual zone can be set to 9 different levels
and is indicated in the corresponding display with a number from
"1" to "9".
Switch on the appliance and adjust the power setting of the cooking
zone using the corresponding slider (H).
Slide your finger on the slider to the right to increase the power and
to the left to decrease it (or switch it off).
Cookware recognition
Each induction cooking zone has a minimum vessel detection limit
that varies depending on the material of the vessel being used. For
this reason,
use the cooking zone that best matches the diameter of the vessel.
If the symbol "
"appears on the display of a cooking zone, this
means that:
• the vessel used is not suitable for induction cooking.
• the diameter of the cooking utensil used is smaller than that
allowed by the appliance.
• there is no cooking utensil on the top.
Residual heat
H
"
"
If the temperature of a cooking zone is still high (above 65°) after
it has been switched off, the display for that zone shows the symbol
H
"
" (residual heat). The message will only disappear when there is
no longer a risk of burning.
Bridge (Flexible cooking zones)
This function combines the front and rear cooking zones into one
larger cooking area.
Special care must be taken to ensure that the cooking utensil is
placed correctly on the cooking zones (Fig. 5).
To activate the Bridge function, simultaneously press the two Sliders
(H) of two adjacent cooking zones (1-2 /3-4).
The illuminated "bridge" function symbol (N area) "
appear next to the display of the two cooking zones to indicate that
the function is active. At this point, the power of the "bridge" zone
can be set.
NOTE: adjustments to the "bridge" zone are made using the slider
and the sensor buttons on the front zone.
To deactivate the Bridge function, simultaneously press the two
Sliders (H) of the two adjacent cooking zones. The illuminated
"bridge" function symbol "
"/"
-
-
PANNELLO COMANDI
2
1
1
2
"
"
-
"/"
" will
-
-
" goes out.
4
3
3
4
Power boost (Fast warm-up) "P"
This function further reduces the cooking time of a zone by raising
the temperature to the maximum power setting for 10 minutes. When
this time has elapsed, the cooking zone power automatically returns
to level "9". This function is suitable for heating large quantities of
liquid (e.g. water for cooking pasta) or other food in a very short
time.
To activate this programme, slide your finger all the way to the right
on the slider (I zone) until the "P" symbol appears on the cooking
zone display. To deactivate the function before the 10 minutes have
elapsed, simply move the slider to a different power setting.
Power Boost cannot be selected when the Bridge function is active.
Automatic pre-heating "A"
All cooking zones feature an automatic pre-heating function. This
function is suitable for heating a cold cooking utensils (cold food)
in a short time (e.g. water or other food). When the function is
activated, the hob is set to maximum power for a certain period
of time, after which it automatically returns to the original power
setting.
This function can be activated for all power settings (1 to 9), but not
for Power Boost, or Warming (Keep the cooking utensil warm). The
preheating time depends on the
selected cooking level. To activate the function on one of the
cooking zones, press and hold the corresponding slider (I zone)
for 3 seconds until the "A" symbol appears on the display (L zone),
alternating with the selected power setting.
Cooking level
1
2
3
4
5
6
7
8
9
P
Keep warm
(WARMING function)
The hob has a special program that is pre-set for certain types of
cooking. The "Warming" program sets the power of the selected
cooking zone to 42 °C to keep cooked food warm. To activate this
program, press the G key once. The "Warming" symbol
up on the display of the cooking zone (P zone). The time limit for
this function is 2 hours, after which the function is automatically
deactivated.
Automatic pre-heating
(seconds)
40
72
120
176
256
432
120
192
Not available
Not available
lights
EN
11

Publicité

loading

Ce manuel est également adapté pour:

Fch 604 id ts whFch 804 id ts bkFch 804 id ts wh