BDR Thermea Group SCB-17B Notice D'installation Et D'utilisation page 19

Parameter
SP172
Solar pump speed max
SP284
Tdiff extra tank
4 Settings
4.1 Introduction to parameter codes
Fig.19 Code on a HMI T-control
...... ........ ....... ......
00:12
....................
..... ... ....... .... .. ..... ....
....... .... .. ..... ....
....... ........... CP010
..... ... ....... ....
..... ... ....... ....
..... ... ....... .... .. ..... ....... .... ..... .......
........ .......
Fig.20 First letter
Fig.21 Second letter
7801273 - 1 - 29062022
Description Menu path
Sets the solar pump
maximum speed ex­
> Solar Systems > Ad­
pressed as a percent­
vanced
age for deltaT speed
control.
Sets the switch-on dif­
ference temperature to
> Solar Systems > Ad­
transfer solar heat from
vanced
the main solar tank to
the additional solar
tank. If the temperature
difference between the
main solar tank and the
additional solar tank is
bigger than or identical
to the switch-on tem­
perature difference,
then a heat exchange
pump is switched ON
and the solar heat will
be transferred from the
main solar tank to the
additional solar tank.
.........
.......
...
......
.....
CP010
AD-3001373-02
CP010
AD-3001375-01
CP010
AD-3001376-01
Options
30 100 %
> Installation Setup
1 20 °C
> Installation Setup
The controls platform makes use of an advanced system to categorise
parameters, measurements and counters. Knowing the logic behind these
codes, makes it easier to identify them. The code consists of two letters
and three numbers.
The first letter is the category the code relates to.
A Appliance: Appliance
B Buffer: Hot water tank
C Circuit: Zone
D Domestic hot water: Domestic hot water
E External: External options
G Gas fired: Gas-fired heat engine
H Heat pump: Heat pump
M -: Combustion system
N Network: Cascade
O Oil fired: Oil-fired heat engine
P Producer: Central heating
Category D codes are appliance controlled only. When the domestic hot
water is controlled by an SCB, it is handled like a circuit, with C-category
codes.
The second letter is the type.
P Parameter: Parameters
C Counter: Counters
M Measurement: Signals
en
4 Settings
Factory setting
100
6
19