BDR Thermea Group SCB-17B Notice D'installation Et D'utilisation page 18

en
3 Installation
Parameter
SP332
Min solar pump power
SP342
Max solar pump power
SP352
Pulse energy counter
SP129
Solar pump type
SP162
Solar pump speed min
18
Description Menu path
Sets the minimum solar
power at minimum
> Solar Systems > En­
pump speed. This is the
ergy management
thermal power transfer­
red by the pump. It is
used for calibration.
Minimim solar power is
zero Watts when the
pump is off.
Sets the maximum so­
lar power at maximum
> Solar Systems > En­
pump speed. This is the
ergy management
thermal power transfer­
red by the pump. It is
used for calibration.
Minimim solar power is
zero Watts when the
pump is off.
Sets the pulse valency
of external energy
> Solar Systems > En­
counter(s). This is the
ergy management
amount of energy cor­
responding to one
unique pulse generated
by the external energy
counter. This is used
for calibrating the ener­
gy counter that will be
stored in the enrgy sig­
nal. The external ener­
gy counter will increase
the frequency of the en­
ergy pulses, i.e. num­
ber of pulses per sec­
ond as the produced
energy increases, and
vice versa.
Select which solar
pump type is used in
> Solar Systems > Ad­
the installation.
vanced
Sets the solar pump
minimum speed ex­
> Solar Systems > Ad­
pressed as a percent­
vanced
age of the maximum
speed for deltaT speed
control.
Options
0 65.535 kW
> Installation Setup
0 65.535 kW
> Installation Setup
0 65535 W
> Installation Setup
0 PWM pump
> Installation Setup
1 LIN pump
2 On off
0 100 %
> Installation Setup
Factory setting
0
5
1
0
0
7801273 - 1 - 29062022