tau DC19 Notice D'installation page 30

DL1 3 yellow flashes
Door won't open in "BLOC-
CATA CHIUSA" (LOCKED)
program with EMERGENCY
input.
Battery is connected, but
door won't open in case of
power failure.
MANUFACTURER'S DECLARATION OF INCORPORATION
(in accordance with European Directive 2006/42/EC App. II.B)
Manufacturer:
Address:
Declares under its sole responsibility, that the product:
designed for automatic movement of:
for use in a:
complete with:
Model: DC19
Serial number: see silver label
Has been produced for incorporation on an access point (swing gate) of for assembly with other devices used to move
such an access point, to constitute a machine in accordance with the Machinery Directive 2006/42/EC.
Also declares that this product complies with the essential safety requirements of the following EEC directives:
- 2014/35/EU Low Voltage Directive
- 2014/30/EU Electromagnetic Compatibility Directive
and, where required, with the Directive:
- 2014/53/EU Radio equipment and telecommunications terminal equipment
Also declares that it is not permitted to start up the machine until the machine in which it is incorporated or of which
it will be a component has been identified with the relative declaration of conformity with the provisions of Directive
2006/42/EC.
References to the relevant European harmonised standards used:
EN 61000-6-2; EN 61000-6-3; EN 60335-1; ETSI EN 301 489-1 V1.9.2; ETSI EN 301 489-3 V1.6.1
EN 300 220-2 V3.1.1; EN 12453:2000; EN 12445:2000; EN 60335-2-103; EN16005..
The manufacturer undertakes to provide, on sufficiently motivated request by national authorities, all information
pertinent to the quasi-machinery.
Sandrigo, 19/11/2018
Name and address of person authorised to draw up all pertinent technical documentation:
Loris Virgilio Danieli - via E. Fermi, 43 - 36066 Sandrigo (Vi) Italy
Encoder not working
Controller is set on "BLOCCATA CHI-
USA" (LOCK) program and DIP # 1 on
SW1 is set on OFF.
DIP # 3 on SW1 is set on OFF.
Type:
Commercial name:
sliding door opener
_________________________________________
30
Check the encoder cable or re-
place the encoder as required.
Select a different program, or
set the DIP # 1 on SW1 to ON
to enable EMERGENCY input.
Set DIP # 3 on SW1 on ON to
enable automatic opening in
case of power failure.
TAU S.r.l.
Via E. Fermi, 43 - 36066 Sandrigo (Vi) - ITALY
Electronic control unit
Sliding doors
Residential / Communities environment
Battery charger
DC19
Control panel for for automatic
Legal Representative
Loris Virgilio Danieli