tau DC19 Notice D'installation page 27

FUNCTION
7 ENTRANCE
CH/PP
FUNCTION
8
ENTRANCE
STOP/ ANTI-PANIC
9 INTERLOCK FUNCTION
OPENING PRIORITY
10
(INTERLOCK)
11 INSIDE SENSOR TEST
12
OUTSIDE SENSOR TEST
Dip switch SW2
1
2
3
DOORS
4
DIRECTION
If the automatic door has a single leaf opening to the right, it is necessary to reverse
the controls of the dip switch 4 as follows: ON: opening towards the left - OFF: opening
towards the right (standard)
5
6
BATTERY CHARGER KEY
Key:
LED steady on;
GREEN LED – battery charger
status
off
flashing every 2 seconds
continuous flashing
flashing every 4 seconds
steadily lit
ON Enables the Step-by-Step function on input 19.
OFF Enables the CLOSING function on input 19.
ON
Enables the STOP function on STOP/ANTI-PANIC input.
OFF
Enables the ANTI-PANIC function on STOP/ANTI-PANIC input.
ON
Enables INTERLOCK function
OFF Disables INTERLOCK function
With ACTIVE INTERLOCK function. Set in ON on the control board
ON
that must have LOW priority.
With ACTIVE INTERLOCK function. Set in OFF on the control board
OFF
that must have HIGH priority.
Enables internal sensor test – the test is carried out on the input,
ON
PICTURE1
OFF
Disables the test on the input, PICTURE1
Enables external sensor test – the test is carried out on the input,
ON
PICTURE2
OFF Disables the test on the input, PICTURE2
ON
OFF Keep the Dip switch in OFF
ON
OFF
Keep the Dip switch in OFF
ON
OFF Keep the Dip switch in OFF
ON
Opening towards the right
OFF Opening towards the left
ON
OFF Keep the Dip switch in OFF
ON
OFF Keep the Dip switch in OFF
LED flashing;
battery charger off;
initial slow charge;
under fast charge;
in backup;
battery charged;
27