stayer SSP L20 Instructions D'emploi page 20

= Weight
L =Sound power level
WA
L =Sound pressurelevel
PA
=Vibration
The values givenarevalid for nominalvoltages [U]230/240
V-50/60 Hz - 110/120 V- 60Hz. For lower voltage and models
for specific countries, these values can vary.Please observe
the article number on the type plata of your machine.The
tradenamesoftheindividualmachines may vary.
NoiseNibration lnformation
Measuredsoundvalues determined according to EN 62841-1.
Typically the A-weighted noise levels of the product are: See
technical data table (page 5).
Wear hearing protection!
Vibration total values ah (triax vector sum) and uncertainty K
determined according to EN 62841-1:
Cutting board: a =14m/s , K=1.5 m/s
2
h
Cutting wooden beam: a =19.5m/s
h
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given in
EN 62841-1 and may be used to compare one tool with another.
lt may be used for a preliminaryassessment of exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for different
applications,with different accessories or poorly maintained, the
vibration emission may differ. This may significantly increase the
exposure leveloverthe totalworking period.
An estimation of the levelof exposure to vibration should also
take into account the times when the tool is switched off or when
it is running but not actually doing the job. This may significantly
reduce theexposure leveloverthetotal working period.
ldentify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the
accessories,keepthe hands warm,organisationof work pattems.
,
2
, K=1.5m/s .
2 2
ENGLISH
20
20