Kenwood KM260 Serie Manuel D'instructions page 10

To dismantle the juicer reverse the assembly procedure but press the pulp
container release lever in order to remove the pulp container from base unit.
G Alternatively if you want to juice a large quantity of fruit or vegetables and
just want to empty the beaker and pulp container carry out the following
procedure:-
1 Switch off and unplug the mixer.
2 Unlock the attachment lid and lift off.
3 Lift out the filter,
4 Swivel the beaker holder to the side, lift off the beaker and empty.
5 Press the pulp container release lever and rotate the pulp container anti-
clockwise and lift off.
6 Empty the pulp container of waste.
7 Re-assemble the unit.
important
If the juicer starts to vibrate, switch off and empty the pulp from the filter.
G
(The juicer vibrates if the pulp becomes unevenly distributed).
Maximum capacity that can be processed at one time is 500g of fruit or
G
vegetables.
Some very hard foods may make your attachment slow down or stop. If this
G
happens switch off and unblock the filter.
G Switch off and empty the pulp and juice containers regularly during use.
hints
G Insert soft food slowly to get the most juice.
Vitamins disappear - the sooner you drink your juice, the more vitamins
G
you'll get.
If you need to store the juice for a few hours put it in the fridge. It will keep
G
better if you add a few drops of lemon juice.
G Don't drink more than three 230mls (8 fl.oz.) glasses of juice a day unless
you're used to it.
Dilute juice for children with an equal amount of water.
G
G Juice from dark green (broccoli, spinach etc) or dark red (beetroot, red cabbage
etc) vegetables is extremely strong, so always dilute it.
Fruit juice is high in Fructose (fruit sugar), so people with diabetes or low
G
blood sugar should avoid drinking too much.
care and cleaning
Always switch off and unplug before removing attachment from mixer.
G
Dismantle the attachment fully before cleaning.
G
G For easier cleaning always wash the parts immediately after use.
Never let the base unit get wet.
G
Some foods, eg carrot, will discolour the plastic. Rubbing with a cloth
G
dipped in vegetable oil helps remove discolouring.
base unit
Wipe with a damp cloth, then dry.
G
filter
Clean using a soft brush.
G
Check the filter regularly for signs of damage. Do not use if
G
the filter is damaged. Refer to "service and customer care".
other parts
G Wash, then dry. Alternatively they can be washed on the top rack of your
dishwasher. A short low temperature programme is recommended.
Multi food grinder AT281
Use the multi food grinder to process raw and cooked meat; fish and nuts.
safety
Always ensure bones and rind etc are removed from the meat before
G
mincing.
When mincing nuts only feed a few down at a time and allow the scroll to
G
pick them up before adding any more.
G Always use the pusher supplied. Never put your fingers or utensils in the
feed tube.
Warning - the cutting blade is sharp, handle with care both in use and when
G
cleaning.
Ensure the attachment is secured in position before switching on.
G
key
ring nut
multi food grinder screens: medium, coarse (due to model variants only 1
screen may be supplied)
cutter
scroll
multi food grinder body
tray
pusher
to assemble
1 Fit the scroll inside the multi food grinder body.
2 Fit the cutter – cutting side outermost
otherwise you could damage your multi food grinder.
3 Fit a multi food grinder screen
4 Loosely fit the ring nut.
to use the multi food grinder
1 Raise the mixer head.
2 With the multi food grinder in the position shown
the end of the scroll with the corresponding slots in the drive outlet.
3 Push the multi food grinder into the outlet and turn clockwise until it locks
into place.
4 Tighten the ring nut manually.
5 Fit the tray .
6 Thaw frozen food thoroughly before mincing. Cut meat into 2.5cm
(1") -wide strips.
7 Switch to maximum speed by turning the speed switch in a clockwise
direction. Using the pusher, gently push the food through, one piece at a
time. Don't push hard – you could damage your multi food grinder.
important
Never operate the multi food grinder attachment for longer than 10 minutes
G
as this could damage your mixer.
The multi food grinder attachment will not operate unless the
G
medium and high speed outlet covers are fitted.
8 Once all the food has been minced, switch off and unplug.
9 Remove the multi food grinder.
care and cleaning
Always switch off and unplug before removing the attachment from the
G
kitchen machine.
Dismantle the attachment fully before cleaning.
G
G Wash all the parts in hot soapy water, then dry thoroughly. Don't wash
any part in the dishwasher. Never use a soda solution.
Wipe the screens with vegetable oil, then wrap in greaseproof paper to
G
prevent discolouring/rusting.
8
(if supplied)
. Ensure it's seated properly –
. Put the notch over the pin.
, align the drive tabs on