Publicité
Les langues disponibles
Les langues disponibles
REPLACING THE CARBON FILTERS (OPTIONAL)
Note:
The carbon filers must be replaced when the display shows FC or every 6 months.
Note:
This procedure is only valid if you installed the carbon filters with your appliance.
1. Remove the grille and the grease filter.
2. Replace the carbon filters.
3. Install the grease filter and the grille.
RESETTING THE SATURATION INDICATOR
The appliance gives an alarm on the display for certain cleaning and replacing intervals, such as replacing the
carbon filters.
1. Make sure that the appliance is switched off.
2. Touch and hold the child lock button for 3 seconds to enter the lock modus.
3. Touch and hold the button for extraction system for 3 seconds to reset the saturation indicator. The operation
indicator shows "CL".
8
Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the breakdown codes.
2. If you cannot find a solution for the problem or the breakdown code keeps re-occuring, contact Inventum-
servicedienst
TROUBLESHOOTING TABLE
Problem
The induction hob does not start.
The operation indicator on the
control panel of the induction hob
shows U.
A cooking zone switches off
automatically. The operation
indicator on the control panel of the
induction hob shows H/h.
38
•
English
Possible cause
There is no mains supply.
The child lock is activated.
The touch buttons are covered with
water or dirt.
There is no pan on the cooking zone. Put a pan on the cooking zone.
The pan is too small (< 14 cm) or not
suitable for an induction appliance.
The cooking-time limit is reached.
Automatic cooking-
Refer to section
time limiter
.
The touch buttons are covered.
Possible solution
•
Do a check if the mains plug is
correctly connected to the mains
socket.
•
Make sure that the mains supply
is on.
Deactivate the child lock. Refer to
Locking and unlocking the
section
appliance
.
Clean the appliance. Refer to section
Daily cleaning
.
Use a pan that is suitable for an
induction appliance. Refer to section
Requirements for pans
.
1. Start the appliance. Refer to
Start cooking
section
.
2. Select a cooking zone. Refer to
Start cooking
section
.
Remove the blockage.
Publicité
