Novy 2916 Mode D'emploi page 48

INCIDENT
A flashing symbol E:1
appears on the temperature
display (2) and an alarm
sounds. The oven has
stopped heating up.
A flashing symbol E:1
appears on the temperature
display (2) and an alarm
sounds. The oven has
stopped heating up.
A flashing symbol E:2
appears on the temperature
display (2) and an alarm
sounds.
A flashing symbol E:3
appears on the temperature
display (2) and an alarm
sounds.
A flashing symbol E:4
appears on the temperature
display (2) and an alarm
sounds. You will see that the
door lock indicator light (3)
is on.
48
CAUSE
The oven door has not been
locked. The door lock has
not worked.
The door is locked but the
door lock indicator light (3)
does not light up.
You have opened the door
before it has been locked.
You have opened the door
during the pyrolytic function.
The door lock has not
worked.
The door has been locked
without a pyrolytic cleaning
cycle being programmed.
SOLUTION
Touch any sensor to stop
the alarm. Call the Technical
Assistance Service.
Touch sensors and (12)
at the same time and the
door should unlock. Call the
Technical Assistance
Service.
Touch any sensor to stop
the alarm. You will see the
time left before the oven
can be used again on the
display (4). When the display
shows 0:00, close
the door before
programming the pyrolytic
function again.
Call the Technical Assistance
Service - your oven is
operating in potentially
dangerous conditions.
The door should be locked
with the pyrolytic function.
Touch any sensor to stop
the alarm. The E4 symbol
will continue to flash
and the time remaining
until the door is unlocked
will be shown on the
display (4). After this time,
indicator light (3) will turn off
and you will be able
to open the door.
Touch any sensor to remove
the symbol E4. Call the
Technical Assistance
Service.