Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To turn off the child lock, keep the
symbol pressed until a long beep sounds.
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
Follow the instructions below to carry out a
pyrolytic cleaning cycle:
1 IMPORTANT: Remove all accessories
(shelves, grids, side supports to hold up the
shelves, telescopic guide rails) from inside
the oven and close the oven door.
2 Touch the On / Off sensor (10).
3 Touch sensor (12).
4 You will see P2 (pyrolytic programme 2)
flashing on the display (4) and the
sensors will light up.
5 You can now change the pyrolytic programme
to P1, P2 or P3 by pressing the
sensors:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2 hours
(16)
1
2
3
4
and
or
Caution
In the event of power failure, your electronic
clock timer settings will be erased and 12:00
will flash on the clock display. Reset the clock
and programme again.
5
6 7 8 9
12
11
10
6 Once the pyrolytic programme is selected,
touch sensor (12). You will hear a double
beep confirming that the programme is set.
7 After a short time, you will see the time
remaining for the selected programme on
the display (4) to end. You will see the cu -
rrent time on the timer display (5). The oven
will start to heat up.
8 After a brief time, the door lock indicator
light (3) will turn on and you will not be able
to open the oven door.
IMPORTANT: At this point, the oven is pro-
grammed and the pyrolytic cleaning cycle is
underway. During the cycle, none of the timer
functions can be selected, except the child
lock. Do not try to open the oven door as it
may interrupt the cleaning process.
45
Publicité
Table des Matières
