Novy 2916 Mode D'emploi page 46

9 When the pyrolytic cleaning cycle has fi -
nished, you will hear an alarm.
10 Touch any of the oven's sensors to stop
the alarm.
11 The oven's heating process has finished.
However, the oven is extremely hot and
cannot be used. The cooling motor will
operate and the indicator light (3) remain
on until the oven cools down.
IMPORTANT
The cooling process may last up to 2 hours
owing to the high temperatures inside the
oven.
12 Once the oven has cooled down, indicator
light (3) will automatically turn off.
CANCELLING THE PYROLYTIC CLEANING CYCLE
To cancel the pyrolytic cleaning cycle,
remember:
a) The oven is cold:
– Switch off the oven by touching sensor
(10).
– You will see the time remaining until the
door unlocks on the display (4).
– When this time gets to 0:00 and indicator
light (3) turns off, you will be able to open
the oven door.
46
13 Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash
from the cleaning cycle. Areas in the oven
that are difficult to access will need to be
cleaned with a non-metallic fibre scourer.
14 Once the oven is clean, do not forget to
replace the supports and accessories.
15 The oven is now ready to be used again.
IMPORTANT: If any incidents are detected in
the programming and operation of this func-
tion, consult the section "Incidents while
Operating the Pyrolytic Function".
b) The oven is hot:
– Switch off the oven by touching sensor
(10). The time 0:00 will be shown on the
central display (4).
– The oven's cooling motor will continue to
operate and the door lock indicator light
(3) will be lit up.
– When the electronics detect that the
oven is cold, you will see the time
remaining until the door unlocks on the
display (4).
– When this time gets to 0:00 and indica-
tor light (3) turns off, you will be able to
open the oven door.