Novy 2916 Mode D'emploi page 47

INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
My accessories and shelf
supports are damaged.
The enamel colour has
changed or stains have
appeared.
A flashing symbol
appears on the temperature
display (2) and an alarm
sounds.
I have programmed the
pyrolytic function, the oven is
working properly but
indicator light (3) is not lit
up.
The pyrolytic programme has
finished but the oven door is
locked.
A flashing symbol E:1
appears on the temperature
display (2) and an alarm
sounds. The oven has
stopped heating up.
1 2 3 4
You have not removed the
accessories and supports
during the pyrolytic cleaning
cycle.
The chemical composition
of some foodstuffs may
cause changes in the
enamel.
The oven is programmed
to carry out a pyrolytic
cleaning cycle but the door
is open.
Indicator light (3) does not
work properly.
The oven has not cooled
down to the safe
temperature.
The oven door has not been
locked. The door is not
closed properly and cannot
be locked.
5 6 7 8 9
12
CAUSE
11 10
SOLUCIÓN
You must replace them and
remove them in later
cleaning cycles.
This is normal and does not
damage the properties of
the enamel.
Close the door to enable the
function to be carried out.
Call the Technical Assistance
Service.
Wait until the oven cools
down and indicator light (3)
turns off.
Touch any sensor to stop the
alarm. Check the door and
make sure that it is closed
properly.
47