Sony SSC-DC134 Mode D'emploi page 5

ATTENTION
If installing the camera on the ceiling, be sure it is secure. If not
securely installed, the camera may fall and injury may occur.
If the camera is installed on the ceiling using equipment such as a
bracket, housing and motored swivel base (pan/tilt), do the following:
* Use tripod screws and securely tighten them with a driver. Order the
tripod screws (Sony Part No. 3-174-693-01) from your nearest Sony
dealer.
¢ Install the tripod adapter on a flat surface.
In the event of any problems with the operation of the camera, contact
your authorized Sony dealer.
olor:} drolamclavom ot0lavei(ie)a me) Ml at-1a 0-3
@ CICS adjustment ring
The C/CS ring to adjusts the back focus to suit the type of lens fitted
(C-mount or CS-mount). The factory setting is set to CS-mount. After
adjusting, be sure to lock the back focus with the @ LOCK screw.
© Tripod adapter (On SSC-DC134, the tripod adapter is attached
on top of the main body. On the SSC-DC132P/SSC-DC134P/
DC138P, it is attached underneath the main body.)
The tripod adapter can be attached to either the top or bottom of the
camera using the 4 attached screws. Use the tripod adapter screw hole
to fix the camera to a mounting bracket. The mounting screw must be of
the following type.
1/4" UNC (20 pitch) i) 2
2: 4.5 mm + 0.2 mm (ISO standard),
or 0.197" (ASA standard) 13
© LENS connector (4-pin)
When using an auto iris lens, plug the lens plug into this socket. The
lens cable plug will have to be replaced with the plug supplied before
insertion. You can only connect the DC servo auto-iris lens.
@ Back focus LOCK screw
After adjusting the @ C/CS adjustment ring to match the type of lens
you are using, turn this screw with a screwdriver to lock the back focus.
© Lens mount (C- or CS-mount)
Used to attach a C- or CS-mount lens.
© Lens mount cap
Keep in place when not attaching a lens to the camera.
BLC (back lighting compensation) ON/OFF switch
When switched on, this function adjusts exposure to compensate for
situations where the subject is lit from behind.
© CCD IRIS ON/OFF switch
When using a manual iris lens, the CCD-IRIS function automatically
adjusts the shutter speed to maintain a suitable exposure level.
© VIDEO OUT connector
This coaxial connector (BNC-type) outputs the video signals.
@® GND (ground) terminal (SSC-DC134/DC134P)
Connect this terminal to the ground.
@® AC 24V screw terminals (SSC-DC134/DC134P)
Connect to an external power supply of AC 24V.
DC 12V screw terminals (SSC-DC132P)
Connect to an external power supply of DC 12V.
@ Power cabie (SSC-DC138P)
Connect to an external AC power supply of 220V to 240V.
@® V PHASE (vertical phase) +/- screw (SSC-DC134/DC134P/
DC138P)
Use this screw to compensate for vertical phase discrepancies which
can occur when multiple cameras are connected to a switching device.
Each camera's output is synchronized to the frequency of the power
supply.
@ IRIS LEVEL WH adjustment screw
Use to adjust the iris level when using a DC servo lens.