Husqvarna CL400i Manuel D'utilisation page 19

6. Remove the screw (F) and remove the drill head (G)
from the shaft (H). (Fig. 58)
7. Use compressed air to clean the product. Make sure
that all dirt, grass and other unwanted materials are
removed.
8. If it is necessary, remove dirty grease with an
applicable solvent.
9. Clean all components with an applicable solvent and
lubricate all components.
10. Apply water-repellent grease on the shaft. (Fig. 59)
To clean the battery and the battery
charger
WARNING:
the battery charger with water.
Troubleshooting
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem
The motor does not start.
The drill does not rotate.
The drill continues to rotate when the
drill operation bail is released.
The product does not operate cor-
rectly.
The product does not move when the
drive bail is engaged.
The drill head cannot be removed.
1698 - 004 - 04.12.2023
Do not clean the battery or
Troubleshooting
Cause
The battery is not charged.
The battery is not installed correctly.
The battery is defective.
The control panel is defective.
The belt is worn out.
The belt has moved out of the pulleys.
The lever does not put sufficient tension on the belt.
The wire from the drill operation bail is worn or damaged.
The drill is worn or damaged.
The drill is not installed correctly.
The wire from the drive bail is worn or damaged.
The transmission belts are worn.
The chain is broken or does not have sufficient tension.
The clutch discs in the transmission housing are worn.
There is unwanted material in the unit.
There is oxide in the system.
WARNING:
substances to clean the battery.
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
Do not use any chemical
19