Publicité
Les langues disponibles
Les langues disponibles
9. Reinstall T1、T2、T2A、T2B temperature sensor
plug electronic expansion valve and tie up the
temperature sensor wires.
NOTE
The wire body needs to pass through the wire
groove from the water receiving tray and be
stuck on the hook of the water receiving tray.
Break the sponge.
Remove knockouts as
shown in the gure.
Hook the wire into the
buckle and go down
from the wire slot.
Sponge paste reset.
Page 24
10. The evaporator is assembled in place.
11. Reinstal evaporator cover plate.
12. Connect the wire according to the wiring
diagram.
Use cable ties to bind and
x the environmental
temperature sensitive bag
as shown in the gure.
Publicité
