Publicité
Les langues disponibles
Les langues disponibles
V 4.0
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problems
Tool runs at normal
speed, but loses
power under load.
Tool runs slowly.
Air flows slightly
from exhaust.
Tools will not run.
Air flows freely
from exhaust.
Tool will not shut
off.
Loss of power or
erratic
performance.
Visit www.princessauto.com for more information
18 Gauge Pistol Grip Air Shear
Possible Causes
Motor parts worn.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by dirt.
Air regulator in closed
position.
Damage or excessive
wearing of internal
parts.
1. Throttle valve o-ring
dislodged from seat
inlet valve.
2. Trigger mechanism
jammed or dirty.
Excessive drain on the
air hose. Incorrect size
or type of hose
connectors.
Moisture or restriction
in the air hose/tank
Air compressor has
insufficient flow.
Suggested Solutions
1. Have a qualified technician service
the tool.
2. Replace tool or parts.
1. Check air inlet filter for blockage.
2. Pour air tool lubricating oil into air
inlet as per lubrication instructions for
clearing shipping grease.
3. Operate tool in short bursts to clear
debris.
4. If tool still jammed, clean tool and
lubricate per lubrication instructions.
Open the air regulator to desired
airflow.
1. Have a qualified technician service
the tool.
2. Replace tool or parts.
1. Replace throttle valve o-rings.
2. Clean trigger mechanism and
lubricate.
Check the air hose and confirm the
hose fitting is correct for the inlet
bushing.
Depressurize system and drain tank
and air hose of water.
Ensure tool is connected to a
compressor with a rate flow that
matches the tool.
8654550
11
Publicité
