GiBiDi SERRA Serie Instructions Pour L'installation page 15

SERRA321
WARNINGS FOR THE USER
• In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical
Service.
• Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel
using original and certified materials.
• The product may not be used by children or persons with reduced physical, sensorial or mental capacities, or
lacking experience and knowledge, unless appropriately instructed.
• Do not access the circuit board for adjustments and/or maintenance.
ELECTRICAL EQUIPMENT
Electric system setup
Set up the electric system as shown (1a - 1b) referring to the electric system regulations and other national
regulations in force. Keep the mains power connections clearly separated from the service connections (photocells,
sensitive frames, control devices, etc.).
The main components are:
1 - Antenna; screened coaxial cable
2 - Electronic control unit container
3 - Electric lock; 1 mm² 2-core (2x1) cable
4 - Key selector; 0,5 mm² 3-core (3x0,5) cable
5 - 24Vdc operators:
• 1,5 mm² 2-core (2x1,5) cable power supply
for a cable length of 6 m max., over it's necessary increase the cable section.
• 0,5 mm² 3-core (3x0,5) cable power supply
for a cable length of 6 m max., over it's necessary increase the cable section.
6 - Omnipolar magnetothermal switch with minimum contact opening of 3 mm
220-230V/50-60Hz control unit power line: min. 1,5 mm² 3-core cable (3x1,5)
(adhere to the regulations in force)
7 - 24V flashing light; 0,75 mm² 2-core (2x0,75) cable
8 - Connector blocks
9 - Photocell transmitter; 0,5 mm² 2-core (2x0,5) cable
10 - Photocell receiver; 0,5 mm² 4-core (4x0,5) cable
CAUTION: It is important that an omnipolar magnetothermal switch with a minimum contact
opening of 3 mm be fitted upstream of the control unit.
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
15
UK