Publicité
Les langues disponibles
Les langues disponibles
To find out more about your product, consult the online EPREL database. As defined in Commission Delegated
Regulation (EU) 2019/2016, all information relating to this refrigeration appliance is available on the EPREL Base
(European Product Database for energy labeling). This database enables you to consult the information and
technical documentation of your refrigeration appliance. You can access the EPREL Database by scanning the QR
code on the energy label of your appliance or by going directly to: www.ec.europa.eu and searching the reference
of your refrigeration appliance.
3. INSTALLATION INSTRUCTIONS
Location
When selecting a location for your appliance you should make sure the floor is flat and firm, and the
room is well ventilated. An average ambient temperature must be observed. This temperature is specific
according to the climatic class of the device:
•
T: This refrigerating appliance is intended to be used at ambient temperatures ranging from 16
°C to 38 °C
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight in out-
buildings or terraces/outside seating areas. If you are placing your appliance in an out-building such as
a garage or annex ensure that it is placed above the damp course, otherwise condensation will occur
on the cabinet. Never place the appliance in a wall recessed or into fitted cabinets or furniture
when it is working, the metal grid at the back may become hot and the sides warm.
Make sure to block the brakes to steady the appliance.
This appliance is designed to operate in climates where the maximum temperature and humidity are
equal to 40°C and 75% respectively.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
22
Publicité
