Ryobi RY18CB23A Mode D'emploi page 9

TROUBLESHOOTING
If these solutions do not solve the problem, contact an authorised service centre.
Problem Possible cause
The power button has not been pressed.
The adaptor is not connected to the adaptor
input or power outlet properly.
The product does not
The fuse is burned.
turn on.
The power supply is malfunctioning.
The cooler door is opened too frequently.
The cooler
There is a large amount of warm or hot food
compartment is too
placed in the cooler compartment recently.
warm.
The product has been disconnected for a
long time.
The food in the cooler The temperature is set too low.
compartment is frozen.
There is a water This is normal and is caused by the fl ow of
fl owing noise coming the refrigerant.
from inside the
product.
There are waterdrops This is normal. This is moisture that has
around the product or condensed to water as it touched the cold
the cooler door gap. surface of the product.
The compressor is This is normal. The noise will be reduced
slightly noisy when once the compressor becomes more stable.
turning on the product.
The F1 code is The product is in low voltage.
displayed on the
control panel.
The F2 code is The condenser fan is overloaded.
displayed on the
control panel.
The F3 code is The compressor starts too frequently.
displayed on the
control panel.
The F4 code is The compressor is not starting.
displayed on the
control panel.
The F5 code is The compressor and the electronics of the
displayed on the product are overheating.
control panel.
The controller is not detecting any
The F6 code is
parameter.
displayed on the
control panel.
The F7 or F8 code The temperature sensor is faulty.
is displayed on the
control panel.
Solution
Press the power button.
Insert the adaptor to the adaptor input and the
power outlet properly.
Replace the burned fuse with a 12 V 6 A fuse.
Make sure that it is original and purchased
from the manufacturer only.
Connect the product to another power supply.
Make sure to close the cooler door when not
putting in or taking out food or beverages.
Do not place warm or hot food in the cooler
compartment to avoid damaging the product.
Clean the cooler compartment and connect the
product to the power outlet again.
Press to set a higher temperature.
-
-
-
Adjust the battery protection mode from High to
Medium or from Medium to Low.
Turn off the product and turn it on again after
5 minutes. If the code shows again, contact an
authorised service centre.
Turn off the product and turn it on again after
5 minutes. If the code shows again, contact an
authorised service centre.
Turn off the product and turn it on again after
5 minutes. If the code shows again, contact an
authorised service centre.
Turn off the product and turn it on again after
5 minutes. If the code shows again, contact an
authorised service centre.
Disconnect the product from the power outlet
for 5 minutes. Connect the product to the
power outlet again. If the code shows again,
contact an authorised service centre.
Contact an authorised service centre.
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
9