Ryobi RY18CB23A Mode D'emploi page 8

TEMPERATURE CONTROL BUTTONS
Adjusts the cooling temperature and the temperature unit to Celsius or
Fahrenheit.
TEMPERATURE DISPLAY
Shows the current temperature inside the cooler compartment. Press the
temperature control buttons to show the temperature setting on the display.
COOLING MODE BUTTON
Toggles between fast cooling (MAX) and energy-saving cooling (ECO).
BATTERY PROTECTION MODE
Protects the installed battery pack from overvoltage. Set H (high) protection
mode when connecting the product to car power. Set M (medium) or L (low)
protection mode when connecting the product to a portable or back-up power
source. (Not for RYOBI ONE+ 18V battery packs)
RESET BUTTON
Resets the product. Activate the reset mode to revert the product to its factory
settings.
POWER BUTTON
Turns the product on or off . Always turn off
the product before moving.
BATTERY FUEL GAUGE
Shows the remaining capacity of each installed
battery pack (RYOBI ONE+ 18V battery packs only).
USING THE CONTROL PANEL
The control panel contains the function controls of the product. When the product is turned on, there is a long beeping sound,
and the control panel turns on for 2 seconds then enters into standby mode.
Function
Temperature unit setting
Battery protection mode
Reset mode
8
Original Instructions
Setting mode functions
1. Turn off the product.
2. Press for 3 seconds to enter E1 mode.
3. Press again to enter E5 mode.
4. Press either or to toggle between Celsius and Fahrenheit.
1. Turn on the product.
2. Press for 3 seconds until the control panel fl ashes.
3. Press again to select the protection setting (H - high, M - medium, and L - low).
1. Turn off the product.
2. Press for 3 seconds to enter E1 mode.
3. Press both and at the same time for 3 seconds to reset the product.