Toparc TPT 25 Mode D'emploi page 9

The cut groove is not
perpendicular to the metal
sheet surface
CERTIFICATION AND SORTING INSTUCTION
Device(s) compliant with European directives. The certificate of compliance is available on our website.
This product should be recycled appropriately
This hardware is subject to waste collection according to the European directives 2002/96/UE. Do not throw out in a domestic bin !
Equipment in conformity with Moroccan standards. The declaration C‫( م‬CMIM) of conformity is available on our website (see cover
page).
Equipment in compliance with British requirements. The British Declaration of Conformity is available on our website (see home
page).
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
TPT 25 - TPT 35 - TPT 40
The torch is not kept perpendicular to the surface of
the part to be cut.
Consumable not properly assembled inside the torch
(untightened nozzle...)
The setting of cutting current is too small according to
the thickness of the part to be cut.
Improve the handling of the torch.
Rectify assembly and tightening of consumables.
Adjust the setting of cutting current on the generator.
EN
9