Beko RCNE720E20PX Manuel D'utilisation page 9

3
Installation
3.1. Appropriate location for installation
Contact an Authorized Service for the installation of the
product. In order to prepare the product for use, refer the
information in the user manual and ensure that electrical
installation and water installation are appropriate. If not,
call a qualified electrician and technician to have any
necessary arrangements carried out.
WARNING:
be held liable for damages that may
B
arise from procedures carried out by
unauthorized persons.
WARNING:
B
in during installation. Otherwise, there is
the risk of death or serious injury!
WARNING:
room where the product will be placed is
A
so tight to prevent passing of the product,
contact the authorised service provider.
jolts.
there must be a clearance of at least 2 cm between
the side walls and the cabin/furniture.
sources such as hobs, heater cores and stoves and at
least 5 cm away from electrical ovens.
kept in humid places.
your product in order to achieve an efficient operation.
If the product is to be placed in a recess in the wall,
pay attention to leave at least 5 cm distance with the
ceiling and the side walls.
In environments where the room temperature drops
below 10°C, the refrigerator will continue to run to
preserve the food in the freezer. However, fresh food
in the fridge compartment might freeze due to the
cold environment.
Manufacturer shall not
Product must not be plugged
: If the door clearance of the
3.2. Installing the plastic wedges
Plastic wedges supplied with the product are used to
create the distance for the air circulation between the
product and the rear wall.
1.
To install the wedges, remove the screws on the
product and use the screws supplied together with
the wedges.
2.
Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
8 /28EN
Refrigerator / User Manual