Gram COMPACT 200 Mode D'emploi page 42

1. Switch off the power at the mains socket.
2. Open the door
3. Dismantle the two screws that hold the control panel at the front and loosen the two
screws the hold the tabletop in the back, pull the complete tabletop a little forward,
and then tilt it upwards.
4. Dismantle the hinge in pos. A, and lift off the door.
5. Dismantle the hinge in pos. B, and mount it in pos. D.
6. Turn the door 180°, and fit it to the hinge in pos. D.
7. Mount the hinge from pos. A in pos. C, and move the bracket from pos. C to pos. A.
8. Re-position and fasten the tabletop.
9. Apply power to the cabinet again.
Models with glass door:
The door should only be reversed by a properly skilled service technician with knowledge
of the product.
Light - glass door
The light in the glass door, can be switched to work in two different ways.
Light constantly on (Lco) or light off when door closed (Ldo).
Push and hold for 5 seconds to change between Lco and Ldo.
Power failure
In the event of a power failure, the control remembers the temperature setting and restarts
the product when power is restored. If the power failure persists for some time, the control
might revert to the factory setting.
Cleaning
Insufficient cleaning will cause that the product will not work at optimum performance, or
eventually it will be defective.
Before cleaning, the product should always be disconnected.
Do not flush the product with water, do not use water jet or steam hose
as this may cause short-circuits in the electrical system.
Cleansing agents containing chlorine or compounds of chlorine as well
as other corrosive means, are not to be used, as they might cause
corrosion to the cabinet and the refrigeration system.
The compressor compartment and in particular the condenser must be kept free
from dust and dirt. This is best done with a vacuum cleaner and a brush.
For the external maintenance and cleaning – Use a hot soapy damp cloth. After
cleaning rinse off with a moist cloth only containing water. Finalize the cleaning
by wiping the cabinet dry, using a dry cloth. Cabinets with stainless steel
exterior, should be treated with stainless steel polish at the end.
The product should be cleaned internally with a mild soap solution at suitable
intervals and checked thoroughly before it is put into operation again.
765042402 Rev. 005 42