Gram COMPACT 200 Mode D'emploi page 37

For refrigerators (R and GR) the set temperature is 5°C (adjustable from 2 to 12°C)
For freezers (F and GF) the set temperature is -18°C (adjustable from -10 to -22°C)
To turn the cabinet off, push and hold
Control lights
The following control lights are located on the display:
Compressor symbol. This LED is on while the compressor is running. Flashes
during temperature setting.
Defrost symbol. This LED is lit constantly during the defrosting cycle.
Evaporator fan symbol. This LED is on while the evaporator fan is running.
Temperature alarm symbol. This LED is on if a temperature alarm occurs.
Keylock
When is lit the display keys are locked.
To unlock the keys:
Push and hold any key for 5 seconds to unlock the controller keys. When the controller has
been successfully unlocked,
Automatic keylock:
Not touching the controller for two minutes, will automatically activate the keylock.
Adjusting the cabinet temperature
To change the set temperature, push
in the display, with one decimal place after the comma.
Push or to change the temperature set point. The new set point temperature is
confirmed/saved by pushing
To exit without change push
After power failure the controller returns to stored settings.
Setting temperature alarm parameters
Adapting the below parameters to suit the real conditions of use, it is important to ensure that
the settings do not make the alarm system either too sensitive or too insensible.
Adjusting the difference between temperature set point and hAL / LAL alarm settings to
narrow, will result in unintended alarms. A narrow gab combined with a too short dAh could
result in an AH alarm, just by opening the door.
765042402
for 5 seconds.
turns off.
once, flashes, and the current set point is shown
once. The display returns to normal operation.
once, or do not touch any key for 60 seconds
Rev. 005 37