MINN KOTA RIPTIDE TERROVA Instructions D'installation page 9

6
ITEM(S) NEEDED
#1 x 6
l. Put a 1/4-20 x 3 1/2" (Item #1) Screw into each of
the drilled locations. The Screw should pass through
the Base Extrusion and the boat deck. If the Rubber
Washers (Item #4) are used, they should sit between
the Base Extrusion and boat deck. Make sure to
secure the motor with screws on each side of the
Base Extrusion.
m. Place a Flat Washer (Item #2) and then a Nylock
Nut (Item #3) at the end of each screw and secure
with a 7/16" Box End Wrench. Make sure all
hardware is secure.
NOTICE: To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
7
n. Replace the Right Sideplate.
o. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
7n
©2024 Johnson Outdoors Marine Electronics, Inc.
#4 x 6 #2 x 6
Right Sideplate Right Sideplate
INSTALLING THE RIPTIDE TERROVA
#3 x 6
Screw Screw
Rubber Washer Rubber Washer
Nylock Nut Nylock Nut
Flat Washer Flat Washer
7o
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Boat Deck Boat Deck
minnkota.johnsonoutdoors.com | 9