MINN KOTA RIPTIDE TERROVA Instructions D'installation page 12

ADVANCED GPS NAVIGATION
GPS Ethernet Connection
Control Control
Head Head
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Coil Cord Coil Cord
Mount Mount
Failure to follow the recommended wire routing for installed features, if equipped, may cause damage to the product and void your
product warranty. Route cables away from pinch points or other areas that may cause them to bend in sharp angles. Routing the cables
in any way other than directed may cause damage to the cables by being pinched or severed. Do not over-tighten cable ties as it may
damage the wires.
1
NOTICE: Your fish finder should be turned off
until this procedure is complete.
a. Place the motor in the deployed position.
b. Locate the Eight Pin Advanced GPS Ethernet
Connector below the Control Head. The Advanced
GPS Ethernet Connector will exit the base of the
Control Head and will rest just below the Control
Head next to the Coil Cord.
12 | minnkota.johnsonoutdoors.com
Ethernet Cable Ethernet Cable
(provided) (provided)
Power Leads Power Leads
CAUTION
Control Control
Head Head
Helix Adapter Cable Helix Adapter Cable
(provided if needed) (provided if needed)
Advanced GPS Advanced GPS
Ethernet Connector Ethernet Connector
Coil Coil
Cord Cord
©2024 Johnson Outdoors Marine Electronics, Inc.
To Helix To Helix
Directly Directly
to Solix to Solix
or Apex or Apex
Eight Pin Eight Pin
Connector Connector