MINN KOTA RIPTIDE TERROVA Instructions D'installation page 6

INSTALLING THE RIPTIDE TERROVA
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the centerline of the boat as
possible. Make sure the area under the mounting location is clear to drill holes and install
nuts and washers. Make sure the motor rest is positioned far enough beyond the edge of
the boat. The motor must not encounter any obstructions as it is lowered into the water
or raised into the boat when stowed and deployed. Consider a quick release or adapter
bracket with the installation of your motor. To view a list of accessories, please visit
minnkota.johnsonoutdoors.com.
TOOLS AND RESOURCES REQUIRED
• #3 Phillips Screwdriver
• Drill
• 9/32" Drill Bit
INSTALLATION
INSTALLING THE RIPTIDE TERROVA
1
ITEM(S) NEEDED
a. Place the trolling motor (Item #5) on an elevated,
level surface, such as a workbench or the tailgate
of a pickup. The motor, as removed from the box,
should be in the stowed position.
b. Make sure the Power Cables are not connected
to a power source or that the battery breaker, if
equipped, is "off."
WARNING
Make sure the motor is on a level surface and is not
connected to a power source.
NOTICE: The trolling motor weighs approximately 65 lb.
Minn Kota recommends having a second person help
with the installation.
6 | minnkota.johnsonoutdoors.com
• 7/16" Box/Open End Wrench
• 9/16" Box/Open End Wrench
• Pliers or Vice Grip
• A second person to help
with the installation
#5 x 1
Deployed Deployed
Power Cables Power Cables
View accessories
available for your
trolling motor
at minnkota.
johnsonoutdoors.com.
• Flat-blade Screwdriver
• Awl or similar Marking Tool
Stowed Stowed
©2024 Johnson Outdoors Marine Electronics, Inc.