MINN KOTA RIPTIDE TERROVA Instructions D'installation page 16

INSTALLING THE PROP
Installing the Prop
1
CAUTION
Disconnect the motor from the battery before
beginning any prop work or maintenance.
a. While holding the Shipping Spacer with a pliers
or vise grip, remove the Prop Nut, Red Shipping
Washer, Prop Washer and Spacer, being careful
not to lose the Drive Pin. Reuse the Prop Nut, Prop
Washer and Drive Pin to attach the Prop.
NOTICE: The Shipping Spacer and Red Shipping
Washer are for shipping purposes only and must be
discarded. The Red Shipping Washer will rust if used to
attach the Prop.
2
ITEM(S) NEEDED
#11 x 1
b. Take the Drive Pin (Item #8) and slide it through the
Hole in the Armature Shaft. Position the Drive Pin
horizontally by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
c. Align the Prop (Item #11) so it is also horizontal
and parallel with the Drive Pin. Slide the Prop onto
the Armature Shaft and Drive Pin until it is seated
against the lower unit.
d. Install the Prop Washer (Item #9) and the Prop Nut
(Item #10) onto the end of the Armature Shaft.
16 | minnkota.johnsonoutdoors.com
#9 x 1 #10 x 1
Prop Prop
Drive Drive
Washer Washer
Pin Pin
Prop Prop
Nut Nut
Shipping Shipping
Spacer Spacer
Red Red
(discard) (discard)
Shipping Shipping
Washer Washer
(discard) (discard)
#8 x 1
2b
Drive Pin Drive Pin
Prop Washer Prop Washer
2c
Armature Armature
Shaft Shaft
Prop Prop
Prop Nut Prop Nut
Prop Prop
©2024 Johnson Outdoors Marine Electronics, Inc.