MINN KOTA RIPTIDE TERROVA Instructions D'installation page 13

2
ITEM(S) NEEDED
c. Identify the keyed Receptacle on the Ethernet
Cable (Item #12). It will be keyed to fit with the Eight
Pin Advanced GPS Ethernet Connector below the
Control Head.
NOTICE: The Ethernet Cable has a Receptacle for the
Advanced GPS Ethernet Connector on both ends. Either
end may be connected.
d. Leading with either Receptacle, take the Ethernet
Cable and run it through the center of the Coil
Cord, starting at the end of the Coil Cord attached
to the Mount and working up towards the Control
Head. Allow enough slack in the cable to attach the
Receptacle to the Advanced GPS Ethernet Connector.
NOTICE: The 30' Ethernet Cable
Ethernet Cable - 720073-4) is provided. If an alternate
length is preferred, alternate cable lengths are available
from humminbird.johnsonoutdoors.com.
NOTICE: Minn Kota recommends routing the Ethernet
Cable through the Coil Cord when making the Ethernet
connection. The cable will be installed from the Mount
to the Control Head through the Coil Cord and parallel
to the Advanced GPS Cable. Bypassing the Coil Cord
when routing the Ethernet Cable is not recommended.
©2024 Johnson Outdoors Marine Electronics, Inc.
#12 x 1
(AS EC 30E - 30'
ADVANCED GPS NAVIGATION
2c
Control Control
Head Head
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Coil Cord Coil Cord
2d
Control Head Control Head
Ethernet Cable Ethernet Cable
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Mount Mount
Eight Pin Eight Pin
Connector Connector
Ethernet Cable Ethernet Cable
Mount Mount
Receptacle Receptacle
Ethernet Cable Ethernet Cable
minnkota.johnsonoutdoors.com | 13