Main Functions; Special Functions - Calibration; Technical Specifications - Futurelight SC-375 Scanner Mode D'emploi

Main functions

- DMX 512 Address settings
The "001" flashes. Use the [
confirm and return to the main menu.
- Pan reverse
This function allows you to invert the Pan-movement. Use the [
this feature or "Off" if you don't wish this feature and press [
- Tilt reverse
This function allows you to invert the Tilt-movement. Use the [
this feature or "Off" if you don't wish this feature and press [
- Test program
This function allows you to run a special demo-test sequences without an external controller, which will show
you some possibilities of using SC-375. Press the [
flash.
- Reset Function
Press [ ] key to run reset. This option enables the SC-375 to index all effects (functions) and return to
their standard positions.

Special functions - calibration

Run a test program, "tSt" must be flashing. Press the [
display will show message "C08" meaning the calibration value of the colour-wheel. Use the [
keys to adjust a new calibration value from range "C01 - C15", the wheel moves in microsteps, so you can
easilly center the current colour.
Press [ ], the display will show "G08", meaning the calibration value of the gobo-wheel.
Use [ ] and [ ] keys to adjust a new calibration value from range "G01 - G15", the wheel also moves in
microsteps, so you can easilly center the current gobo. Now press [
calibration (display shows current colour calibration value) or press and hold [
show "tSt" in order to finish calibration procedure.
Power supply
EU-model: 210/230/250 V AC, 50/60 Hz ~
Power consumption: 400 W
Fuse: T 3.15 A, 250 V
Lamp
MSD 230 V/250 W or MSD 230 V/200 W
Optical System
- High reflecting aluminium-coated parabolic reflector
- Manual focus
- Standard 19° focused beam angle
Colours
- 11 dichroic-filters plus white
- UV-filter
- 3 dichroic semicolours filters
- Colour-wheel with variable rotation speed
Gobos
- 13 static gobos plus full circle
Strobe
- Strobe effect with variable speed (1 - 8 flashes per second)
Motor
- 4 high quality stepping-motors controlled by microprocessors
Electronics
- Intelligent control panel with 3-digit LED display allowing: addressing PAN and TILT reverse, effect
calibration, reset of the unit and built-in test sequence running
- Digital serial input DMX-512
- 4 control-channels:
] and [ ] keys to select required address (001 - 509) and press [
] key to run the test program, the "tSt" will start to

Technical specifications

26
] and [ ] keys to select "On" if you wish
] to confirm and return to the main menu.
] and [ ] keys to select "On" if you wish
] to confirm and return to the main menu.
] and [ ] keys together and hold them until the
] in order to go back to colour
] key until the display will
] to
] and [ ]