Publicité
Les langues disponibles
Les langues disponibles
2. The power supply cord will have TWO buttons on the plug head. Press the
TEST button, you will notice a click as the RESET button pops out.
3. Press the RESET button, again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some
products this it also indicated by a light on the plug head.)
NOTE
Do not use this device to turn the unit on or off.
•
Always make sure the RESET button is pushed in for correct operation.
•
The power supply must be replaced if it fails reset when either the TEST
•
button is pushed, or it cannot be reset. A new one can be obtained from the
product manufacturer.
If power supply cord is damaged, it cannot be repaired. It MUST be replaced
•
by one obtained from the product manufacturer.
NOTE:This air conditioner is designed to be operated under condition as
follows:
Outdoor temp:
Cooling
operation
Indoor temp:
Electronic Work
WARNING:
BEFORE PERFORMING ANY ELECTRICAL OR WIRING WORK, TURN OFF THE
MAIN POWER TO THE SYSTEM.
DISPLAY
POWER
MAIN
SUPPLY
CONTROL
CORD
WARNING for Using R32 Refrigerant
Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
The appliance shall be stored in a room without continuously operating ignition
sources (for example:open flames, an operating gas appliance or an operating
electric heater).
Do not pierce or burn.
Be aware that the refrigerants may not contain an odour.
Appliance should be installed, operated and stored in a room with a floor area
according to the amount of refrigerant to be charged. For specific information on
the type of gas and the amount, please refer to the relevant label on the unit itself.
When there are differences between the lable and the manual on the Min. room
area description, the description on label shall prevail.
Appliance shall be installed, operated and stored in a room with a floor area larger
than 4 m .
Appliance shall not be installed in an unvertilated space, if that space is smaller than
4 m .
Page 6
Page 6
64-109°F/18-43°C (64-125°F/18-52°C
for special tropical models)
60-90°F/17-32°C
NOTE: The cographs are for
explanation purpose only. Your
machine may be slightly different.
The actual shape shall prevail.
Note: Performance may be
reduced outside of these
operating temperatures.
Publicité
