Midea MWMW050CM1A Manuel Du Propriétaire page 5

NOTE
The power supply cord with this air conditioner contains a current detection
device designed to reduce the risk of fire. Please refer to the section Operation
of Current Device for details.In the event that the power supply cord is damaged,
it cannot be repaired-it must be replaced with acord from the Product
Manufacturer.
WARNING
Avoid fire hazard or electric shock.
Do not use an extension cord or an
adaptor plug.
Do not remove any prong from the
power cord.
WARNING
For Your Safety
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
Prevent Accidents
To reduce the risk of fire, electrical shock, or injury to persons when using your
air conditioner, follow basic precautions, including the following:
Be sure the electrical service is adequate for the model you have chosen.
•
This information can be found on the serial plate, which is located on the side
of the the cabinet and behind the grille.
If the air conditioner is to be istalled in a window,you will probably want to
•
clean both sides of the glass first. If the window is a triple-trackty pew it has
creen panel included, remove the screen completely before installation.
Be sure the airconditionerh as been securely and correctly in stalled
•
accordingto the installation instructions in this manual. Save this manual for
possible future use in removing or installing this unit. When handling the air
conditioner, be careful to avoid cutsf romsnarpm etalf ins on front and rear
coils.
Electrical Information
To reduce the risk of fire, electrical shock, or injury to persons when using your
air conditioner, follow basic precautions, including the following:
Be sure the air conditioner is properly grounded. To minimize shock and fire
•
hazards, proper grounding is important. The power cord is equipped with a
three-prong grounding plug for protection against shock hazards.
Your air conditioner must be used in a properly grounded wall receptacle. If
•
the wall receptacle you intend to use is not adequately grounded or
protected by a time delay fuse or circuit breaker, have a qualified electrician
install the proper receptacle. Ensure the receptacle is accessible after the unit
installation.
Do not run air conditioner without side protective cover in place.This could
•
result in mechanical damage within the air conditioner.
Do not use an extension cord or an adapter plug.
•
Operation of Current Device
(Applicable to the unit adopts current detection device only)
The power supply cord contains a current device that senses damage to the
power cord.
To test your power supply cord do the following:
1. Plug in the Air Conditioner.
Grounding type wall receptacle
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply
cord with 3-prong
grounding plug
and current
detection device.
Page 5
Page 5